AQ and VectorDD...

[Jdmagoo]

Just wondering what motor numbers on the AQ people are using for he following:

- CAM STAB PITCH
- CAM STAB ROLL
- CAM CONTROL PITCH
- CAM CONTROL ROLL
- CAM CONTROL YAW

Also, does the 5v bridge need to be soldered on the AQ for the above to work?

Finally, if I'm using a PPMSUM receiver, does this impact the wiring from the AQ to the alexmos board?

Thanks in advance

James

[joebar.rc]

[Jdmagoo]

[joebar.rc]

[Jdmagoo]

[joebar.rc]

Right, all is connected
Ok, you can do that off course, keep in mind that a diode will drop 0.3-0.7V and you need to choose one that can handle around 1-2A for small motors..
What you also can do is attaching a low cost Bluetooth adapter on the rx-tx lines, I have that and it's working great. The only reason than to have an USB connected is uploading firmware.

[plexus]

viewed on the web:
http://www.youtube.com/watch?v=8_fAoGj5MWg
Alain