Hi all,
Today I made a couple of static logs for the "fully temperature compensated IMU" procedure.
My board is a brand new AQ6 board with DIMU extension board.
All sensors give perfect results over the total temperature range, but the tempature sensor does not.
Somewhere in the temperature range below -4 degrees C something is wrong (see attached picture).
The temperature data over this temperature look normal.
All my static logs show a similar pattern as the one posted here.
Did anyone encounter a similar problem, know what the possible cause could be or how to solve it?
Where is the temperature sensor located? Is it on the main board or on the DIMU extension board?
Flying behaviour with just the onboard MAG calibration and DIMU tare is great.
Best regards,
Jan Willem
The Netherlands