Page 1 of 1

Temperature compensation & onboard calibration

PostPosted: Fri Jun 27, 2014 2:35 pm
by rput
Hi guys,

just received some new DIMU boards that Jussi kindly put on the AQ for me. After reading on the forum and Wiki I do not see anywhere how to do both a temperature compensation calibration and the onboard calibration. Is this possible or should I do a full calibration for this?

Thanks,
Richard

Re: Temperature compensation & onboard calibration

PostPosted: Fri Jun 27, 2014 3:15 pm
by bluuu
you CAN do full calibration

Re: Temperature compensation & onboard calibration

PostPosted: Fri Jun 27, 2014 3:39 pm
by rput
yes I understand that is possible. My question is if you can do a temperature calibration in combination with the onboard calibration.

Re: Temperature compensation & onboard calibration

PostPosted: Fri Jul 04, 2014 6:10 pm
by rput
I suppose everyone is at MF.... Perhaps I will ask the question later :)

Re: Temperature compensation & onboard calibration

PostPosted: Sat Jul 05, 2014 12:18 am
by bn999
No. They are exclusive. One overwrites the other.