Info and discussion about the autonomous Micro FC, suitable for nanos, micros and mini multirotors
by Mullet » Tue Jun 28, 2016 6:54 pm
Somehow pulled the ADC pad on one of my M4s. Is there a way to fix this via scratching some solder mask off somewhere or attaching a small wire to a resistor/cap?
Thanks in advance!
-
Mullet
-
- Posts: 181
- Joined: Sun Dec 28, 2014 5:56 am
- Location: Fairfield County Connecticut
by JussiH » Wed Jun 29, 2016 9:31 am
Only option is to go directly to pin9 on the STM32
-
JussiH
-
- Posts: 2103
- Joined: Thu Jun 21, 2012 9:25 pm
Return to AutoQuad M4 Micro Controller
Who is online
Users browsing this forum: No registered users and 1 guest