CamCruiser FPV folding quad - Autoquad goes FPV

[aBUGSworstnightmare]

... just as a side note: I will use a modified version of the Mav2Telem board + adapter PCB for mounting the M4. This gives a small 'all-in-one' solution.

early prototype of Mav2Telem with expansion socket

side view of the stack-up

new version of the matching M4 adapter PCB (unassembled; received them today)

prototype during testing

O.K. wanna see more pictures what's next?

Old motor mount (as used for the MN3510; standard mount components)

Tarot 4006 motor mount - needed to be larger than standard mounts. PCB mounting screws were replaced with plastic ones to save weight.

comparison between standard and custom motor mount (fits larger motors and has more mounting hole options than standard motor mount); LED PCB fits both versions

Drive train for the new QUATOS CamCruiser (M4 based)

[DUKE40]

Hi Jörg,

great stuff.
Do you have the weight of the arms of the CamCruiser as well?
Will be needed for Quatos;-)

[aBUGSworstnightmare]

[DUKE40]

OK.
What props are those on the picture? I read somethign like 30x15 but that does not make anysense to me.
As far as I can see 16" props would be the maximum on the frame, with larger props the body and the lipo would be already in the rotor disc.

[aBUGSworstnightmare]

[DUKE40]

Hi Jörg,

I will post the weight of the T-Motor props this afternoon when I am back from work.

[DUKE40]

Hi Jörg,

the T-Motor 12x4" props weight 13g.
I will post a picture tomorrow morning.

[DUKE40]

The tarot prop combination you posted weights more than my combination MN3510-15 with T-Motor 12x4 which I just weighted at 132g with the motor mount of the CamCruiser, including an LED stripe of 3 LEDs, like your PCB.

[aBUGSworstnightmare]

145g-9g-21g+5g+13g=133g with T-Motor prop

[DUKE40]

So more or less the same weight