How to disable gimbal stablization

[auhouhz]

Hi, I have a small FPV camera with tilt servo that I've connected to the port 10 of AQ and control it using the AUX 3 (Ch8) knob on my DX8

Radio & Control, Control setup, Gimbal Tilt = Channel 8.
Mixing & Output, Gimbal ports, Roll off, Pitch = 10.

As I am using it for flying FPV, I do not need the stabilization function. I only need to control the tilt for take off and landing. I cannot find any option to turn off the stabilization. Please help.

Thank you.

[joebar.rc]

There is not an option for that, but you could try it with the roll and pitch scaler in the gimbal section setting it close to 0 or even 0.

[auhouhz]

In that case, how can I wire my servo so I can use one channel and port for a simple pwm output? Without assigning it to a gimbal function.

[joebar.rc]

You can't, we've made a gimbal pass though code some while ago but I don't know if it in the development trunk yet. But as said, only for the gimbal.
Also a servo trigger is coded, but simply assign a port to pass though any channel we didn't make.

[auhouhz]

Thanks for the explaination, may I know how can I use the trigger port? Wiring and setting. Thank you.