Re: AQ and AlexMos gimbal - how to ;)
Posted: Fri Jan 31, 2014 1:39 pm
AutoQuad Forum
AutoQuad :: Autonomous Multi Rotor Vehicle Controller
https://forum.autoquad.org/
AQ and AlexMos gimbal - how to ;)
Page 3 of 3
Posted: Fri Jan 31, 2014 1:39 pmRe: AQ and AlexMos gimbal - how to ;)
Posted: Fri Jan 31, 2014 2:30 pmYou're welcome
Re: AQ and AlexMos gimbal - how to ;)
Posted: Mon Feb 10, 2014 4:45 amFinally got around to connecting the AQ with the gimbal controller. The gimbal controller doesnt seem to like it when the manual pitch is on the same channel as the gimbal pitch from the AQ, it seems to fight itself. Is it correct that if you want to have pitch and roll PWM from the AQ AND manual pitch control you need 3 different leads going to the gimbal, one fore each function?
Re: AQ and AlexMos gimbal - how to ;)
Posted: Mon Feb 10, 2014 10:04 amYou don´t need the FC outputs from the AQ.
Use the gimbal as stand-alone and only connect the tilt passthrough on your radio.
Works fine!
Use the gimbal as stand-alone and only connect the tilt passthrough on your radio.
Works fine!
Re: AQ and AlexMos gimbal - how to ;)
Posted: Mon Feb 10, 2014 10:40 pmRe: AQ and AlexMos gimbal - how to ;)
Posted: Mon Feb 10, 2014 11:03 pmConnecting the FC outputs helps the AM controller know the frame posistion relative to the gimbal and is used to further refine the stabilisation.
I dont use it though, with correct tuning the most recent basecam firmwares are more than adequate for what I need.
Basecam32 supports "Frame IMU" - so that can be used as a reference between the frame and the cam.
I dont use it though, with correct tuning the most recent basecam firmwares are more than adequate for what I need.
Basecam32 supports "Frame IMU" - so that can be used as a reference between the frame and the cam.