Tuning PID from Log Files?

The last Bastion to fine tune your FC matching your airframe & setup

Tuning PID from Log Files?

Postby wangyeee » Thu Apr 02, 2015 11:03 am

Is it possible to calculate proper PID values from AQ log files other than the methods described on the wiki? If it's not feasible, can I tell from the log how to change the current value, e.g. a too large tilt angle P needs to be reduced?
wangyeee
 
Posts: 37
Joined: Sun Feb 22, 2015 5:20 am

Re: Tuning PID from Log Files?

Postby LPR » Thu Apr 02, 2015 4:50 pm

Read the info in the wiki.

http://autoquad.org/wiki/wiki/configuri ... de-tuning/

You can increase and decrease the Max Tilt angle many ways but changing just Tilt angle P does not change the Max angle. If you increase the Tilt P and Increase the out Max you can get a larger Tilt angle.

You can increase of decrease your Tilt angle by increasing or decreasing the Pitch and Roll scale factor on the config page in the QGC.

Larry
LPR
 
Posts: 1323
Joined: Tue Jun 26, 2012 1:29 pm
Location: MN, USA

Re: Tuning PID from Log Files?

Postby wangyeee » Fri Apr 10, 2015 4:10 am

Thx Larry.
But I think I haven't make myself clear. During my tuning process, I found it was difficult to distinguish high/low frequency oscillation. The quad seems to be always oscillating at some frequency. So I want to find some clue from the log file.
wangyeee
 
Posts: 37
Joined: Sun Feb 22, 2015 5:20 am


Return to PID Tuning

Who is online

Users browsing this forum: No registered users and 3 guests

cron