So as I continue to tune and explore my quads abilities I am so far unimpressed with my gps antenna. I get a 3d lock in about 30 seconds upon power up. Once I start flying the quad it often degrades to a 2d lock. Is this common? I feel like I had a more reliable reception with my old diopole, although less acurate... I am running-
32db High Gain CIROCOMM GPS Active Built-in Ceramic Patch Antenna 38*38*6mm
Dielectric antenna
- Center Frequency: 1575.42 ± 3 MHz
- VSWR: 2:1
- Bandwidth: ± 5 MHz
- Impedance: 50Ω
- Highest gain : > 3dBic Based on 7 × 7cm
- Gain Range : >-4dBic at -90 ° <0 <+90 °
- Antenna polarization: RHCP
Amplifier / filter
- Amplifier gain: 30dB
- Noise Figure: 1.5dB
- Filter band attenuation
- 7dB Min f0 + /-20MHz;
- 20dB Min f0 + /-50MHz;
- 30dB Min f0 + /-100MHz
- Output VSWR: <2.0
- DC voltage DC: 3V --- 5V
- Power: 10mA
Specifications:
- Weight: 7g
- Size: 38 * 38 * 6 mm
- Cable length: 10cm
- Connector type: IPEX
- Line color: black
I do not have a groundplane beneath the antenna ... I know I need to add one. Anyone familiar with my current antenna or should I just go buy the recommended 35mm toaglas? and of course add a groundplane..
I have another question regarding missions. I am assuming I will need to do some tuning of my nav pids. What happens when the quad misses a waypoint? Does it turn around and try again? Or loiter?
Thanks guys!!
Luke