I was so happy with this fantastic project until the sudden and unexpected death of the AQ Flightcontrol. Here is a Pic of my Hexacopter with Hardware from viacopter after succesful dynmic calibration
- New AQ-Hexa with Hardware from viacopter
- Hexa_Carbon_small.jpg (95.89 KiB) Viewed 15860 times
After dynamic calibration I wanted to check the compass curves by spinning copter slowly over every axis. The Transcend 8GB class 10 microSD recorded the movements until ca. 3700 when suddenly all Leds went off. Since then AQ-Board is dead. Not even the Power-Led goes on.
Looks very similar to the Thread from leopold1 who experienced the same sad effect.
Hopefully the log will help in this case. LOG_IMU_MAG looks good until it's sudden stop. The only strange curves I found are LOG_VOLTAGE3 to 5. Is this a abnormal behaviour?
Measured the 2 Recoms -> they still output 5V. Current draw of the dead board at 12V is 250mA. Copter runs on 3s 2200mAh.
Hope a forum member or JussiH can help to get the baby airborne
Ulrich