Hello,
after burning one V3, i take care with the second. I killed one highside fets during reducing the pwm with servotester.
i have some question about the VBat jumper. The Vbat side soldered powers the Controller and the 5V Pin (Servocable) from Battery. The middle of Jumper is connected to 5V (Servocable). Is this right ? What is connected to the other side of the jumper ? Where are the 5V from USB connected ? is the supply seperated with diodes ?.
At the second ESC32V3 i have soldered only pulse and gnd to the esc. It survived all tests with different motors and loads.
During the tests, i recognized that sometimes the motor stops very hard with full brake and stays braked. Special for non copter use, i would preffer no brake (spin free at motor off command). It would also prevent from damage the glued magnets.
Another question is , how long is the time with no pulses from the receiver , that the controller disarms ?
During tests twice i had the problem with disarm coming from brownouts of the DSM2-SAT/FBL-System . But this is not a problem from the esc. 1,7ms signal to the Esc , brownout no Pulses, then 1,7ms pulses. ESC disarmed , Motor stops andnot starting again.
If the development Team is interested , i have made some pictures of the burned ESC32.
sorry for my bad english.
best regards
Stephanos