I´m building a small quad with ESC32V3 and the well known Warthox centerplate (http://flyduino.net/Quadrocopter-Center ... n-set-of-2)
I want to show the installation solution I did that keeps a clean mount together with a protected ESC´s and easy access to USB connector from external side.
Attached the file for the small 3DPrinted part used . Used ABS; weights 2g each. M2.5 Bolts screwed directly into 2mm holes in part.
Note the small velcro ("loop" type) below the ESC´s to protect & isolate their botom side against frame surface.
Hope you like
Angel