by Luxar » Tue Dec 15, 2015 7:53 pm
I can't run the calibration from cli interface. With putty I can connect and change settings if I want. But if I run the calibration, the motor start, slows down and then stopped. I must repower the esc to connect again with putty or the ground control...
Am solder another esc to the motor, but this have a wrong timing, at half throttle the motor began to stutter...looking for one "Simonk-esc", this one should work.
All other motors (3) that am connected in the past to the esc work fine...only this one makes me mad !
Am bought this motors for longer flight times, this will work, now I can hover 12 min with the same setup (in past only 6-8 min) but no reserves of power.
I don't want to by new esc or other stuff...
Edit: am using the 2.1.0 r58 b6185 firmware for the esc...with this am using the older motors too....
Greetings from Germany - Ralf