Hi,
i have problems with a Spektrum DX6 an the Autoquad M4v2. I will use the internal CYRF-Receiver on the M4-Board.
- i use the firmware 7.1.1852-hwv8.6-quatos on the board
- Binding works with my Spektrum DX6, DSMX 22ms.
- the radio quality shows 2-3% in QGC...
- and the channels "overlap"... ( Channel 1 (Gas) shows 100% in QGC when it in the middle position and when the gas stick goes over the middle position to the high position the channel 2 (Roll) is active. Same with other channels.
- the servo monitor in the transmitter shows the correct channels.
Whats wrong in my setup? Or is the Spektrum DX6 incompatible with the internal receiver on the autoquad m4v2?
The board works correctly with a Spektrum DX8 from a friend. I have no other hardware for testing...
Thanks for your answers!
UncleF
PS: Sorry for my bad english...