HEy guys, maybe anybody can help me ?
Tried to connect my Alex Mos s-BGC ( FW: 2.407 ) with my AQ6 using PPM. Gimbal was setup properly w/o RC-signal and works fine, but when connecting PPM from receiver to RxRoll like mentioned in manual, i have two effect :
1.) connecting only flight battery : after initialize, gimbal starrt bouncing on roll and tilt
2.) connecting USB to gimbal and plug in flight batterie, all ESC starting beeping like no valid RC-signal
Okay, guess that could be a problem with the Futaba PPM from the FRSky receiver, wo maybe i should try to sue the PWM / Analog function from the gimbal - and this is the point where i´m not sure :
1. where to connect the gimbals inputs at the AQ6 ? (ports)
2. how to set up the gimbals inputs ? i guess PWM (because of the adjusteable frequency )
Any further advise for me how to deal with it ?