by TheBone » Sun Jun 07, 2015 4:15 pm
Thank you very much for your comprehensive answer.
The thread you posted i doesn't know. That makes the soldering much more easier.
If I'm right, on the top side of the ESC (where the USB-Port and the AQ label is), everything is nearly the same. If I want to power the board by the FC. I have to solder the the both solder pads like you did.
The six ports (from right) are for the UART and the rest is not interesting for me, at least at the moment.
On the back side the interesting pads are the five from left (at the lower edge). The two pads on the left sides are for the CAN and the three next to them are for the PWM-Signal.
The connectors for the Motor, the LiPo and the capacitor was left behind at this point.
A few of my questions have already been asked, but I've still got a few left.
For what are the pads which are named below:
TP1
The four: GND + +5V + SCL + SDA
The two ports right of the PWM ports (+5V + GND)
C23
C31
C30
C29
TP2
Once again, thank you very much for your help.