MT 4006-13 with ESC 32 / Motor problems

[fx44]

Hello,

i try to set up an MT 4006-13 with ESC 32
4S / Graupner E-Prop 12-6
testet Firmware :
esc32v2.0.0.r49
esc32v2.1.0.r57

i have done the Curent cal. starting with 10A and every further run +5A
up to the Motor limit (24A)

Slow acceleration is ok, but if try to speed them up fast the engine stops...

Anybody of you runs this setup ? or could you give me any ideas ?

THX
Felix

[aBUGSworstnightmare]

[SuperSharpShooter]

I had to increase the advance on the ESC32 when running a calibration on the mt-4006-13 so that it would complete successfully.

I actually cooked a motor and ESC when running with a 20A current limit with the APC 12x4.5MR on 4s. Turns out the 24A max current listed in the supplied table was for 3s operation. Running that current on 4s took the motor past the power it could handle and the stator wires melted.

I'm only running 11x4.7 props on these motors for now.