by LPR » Fri Aug 08, 2014 2:45 am
CKW
1."The ESC32 with default setting do run my 4014-11"... Does "default setting" means you don't need to alter any parameters? So I can run the 4014-11 without doing calibration?
You do not need to calibrate the ESC32 for many motors but to get the best performance of motors calibration is necessary. I'm using the ESC32 without calibration or parameter changes.
The 4014 are hard to start but run well with defaults.
2. Do you have any idea about my condition? Running about 2.5 seconds then disarms. I don't think it is the matter of battery because both 3s and 6s get the same result.
Try changing timing to get better starts.
3. I soldered TX RX 5V GND of the 6 pins UART, leaving the other two alone. So there are no headers for those two pins and they are not connected into the UART-USB adapter. Is it OK?
You only need the four wire connected.
Larry