Hi,
now my new AQ is ready evrything looks fine, after TARE the HUD show the AQ as expected.
I also did the onboard magnetic calibration according to the documentation. But How can I check that it was successful?
Is there anything I can check?
Holding the AQ in the hand, it does not seem to correctly hold the position, trying to breakout on one side, a little bit later trying to breakout to the other side, suddenly loosing power.
I have the feeling there is still something wrong. I will try to replace the foam I have put on the baro, but this shold only have an impact on the altitude and not on the AQ remaining level or not.
Would be thankful for any hint or advise.