Hi,
I'm probing around with my AR9020 receiver's failsafe settings. Since I'm using the receivers SRXL-bus to communicate with the AQ6 I need to bind the receiver in preset failsafe mode because the 'radio quality' of the SRXL-bus will never go to zero.
So, I've bound the AR9020+2 sats+TM1000 in preset failsafe mode with all controls centered and HOME ACTION switch in LOW position --> craft should return to home in case of a radio signal loss.
Since I was probing around with different settings I ended up with a QGC channel monitor widget showing strange channel numbers.
The screenshot shows the QGC settings and the Channel Monitor widget content. All channels act like configured under CONTROLS SETUP, showing right values in RADIO VALUES, but channel monitor widget is showing strange numbers/values (compare THROTTLE channel!).
Any idea how to fix this?