Yupp.
The trick to get it right is to bring both motors into the same cogging position which is a bit tricky since all motors are manufactured the same - but you need to mount it "mirrored".
We had to use long holes for one motor mount so the base can be turned around the center to bring the magnets/stators into the same position as the opposite motor.
AQ6 Calibration & Calculation Services 2015
16 posts
• Page 2 of 2 • 1, 2
Re: AQ6 Calibration & Calculation Services 2014
by hogster » Mon Feb 24, 2014 9:05 am
- hogster
- Posts: 239
- Joined: Tue Feb 11, 2014 8:59 am
Re: AQ6 Calibration & Calculation Services 2014
by hogster » Mon Feb 24, 2014 11:27 pm
Wow that sounds like it involved a lot of trial and error 
Great that you got it working though, well done!
Great that you got it working though, well done!- hogster
- Posts: 239
- Joined: Tue Feb 11, 2014 8:59 am
Re: AQ6 Calibration & Calculation Services 2014
by baoxian_zhang » Thu Mar 13, 2014 8:27 am
Great and impressive!
- baoxian_zhang
- Posts: 2
- Joined: Thu Mar 13, 2014 7:53 am
Re: AQ6 Calibration & Calculation Services 2014
by kinderkram » Mon Mar 24, 2014 9:38 am
YES, we CAN!
As an additional service Marcus will offer soldering the DIMU connectors to existing AQ6 boards and needed parts for the ESC32 CAN bus upgrade. Please contact him via PM.
As an additional service Marcus will offer soldering the DIMU connectors to existing AQ6 boards and needed parts for the ESC32 CAN bus upgrade. Please contact him via PM.
- kinderkram
- Posts: 2911
- Joined: Fri Jun 22, 2012 7:47 am
Re: AQ6 Calibration & Calculation Services 2014
by kinderkram » Mon Mar 24, 2014 12:06 pm
March of the bugs:
AQ6 equipped with DIMU and ESC32 with CAN bus.
- DSC03774-L.jpg (82.65 KiB) Viewed 17337 times
AQ6 equipped with DIMU and ESC32 with CAN bus.
- kinderkram
- Posts: 2911
- Joined: Fri Jun 22, 2012 7:47 am
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 5 guests