New Octo build

[chschmid]

After my terrible crash, most possibly caused by a lost caps due to vibs I was learning some 3D drawing in the last days and built a housing for ESC32 and caps. Hopefully this will prevent the caps from falling off.
The first fairly good PLA print was ready this morning. I am still experimenting a little with the printer settings.

Cheers
Christof

ESC32 Halter.jpg (27.36 KiB) Viewed 24845 times

ESC32 Halter 1.jpg (30.03 KiB) Viewed 24845 times

[teramax]

This is realy awesome

Do you think gluing only is enough? Hm, i would ad some supporttube or inlet in the arm.
Maybe somthing 3D printed.

Chris all thumbs up for your projekt!

[chschmid]

[teramax]

yes exactly, just to prevent not to sqeece the arms to much.
Nice build as always.

[chschmid]

I am working on the power distribution.

Whats the better solution regarding magnetic fields and EMI:

1. a closed ring wire with connections
2. an open ring wire with Connections

Power Disribution.png (29.02 KiB) Viewed 24727 times

Thanks for your comments

Cheers
Christof

BTW
I am making some progres

[chschmid]

Ok, no answers. So I will try it out.
The distribution is ready. It is completly 3D drawn and can be replicated any time.

copper ring 4mm2

housing with copper ring

insulation added

two (+ and -) added to one ring

The motormounts are ready too. This is the 3D printed proof of concept.

Motormount ready

dampened ESC32 Mount

cheers

Christof

[teramax]

maybe theres no answer cause no one realy knows
So it´s on you to proof!

Ahm btw. perfekt as always Respekt

[Jdmagoo]

[chschmid]

[chschmid]