Static, Dynamic, Log File Analysis, Troubleshooting
by chschmid » Sat Aug 31, 2013 8:07 pm
I lost the baro at the crash two weeks ago.
Can I static calibrate the board without baro?
Thanks for advice.
Cheers
Christof
-
chschmid
-
- Posts: 1800
- Joined: Wed Jul 11, 2012 7:41 pm
- Location: Herrliberg, Switzerland
by Kisssys » Sun Sep 01, 2013 3:28 am
Yes, baro is not used and it is far enough from the sensor group that changing it should be ok. You could always solder a second sensor on the other pads also and select it.
Steve
Kisssys
-
Kisssys
-
- Posts: 1340
- Joined: Sat Jun 23, 2012 9:23 pm
by chschmid » Sun Sep 01, 2013 5:55 am
Thanks for the good news Steve.
Cheers
Christof
-
chschmid
-
- Posts: 1800
- Joined: Wed Jul 11, 2012 7:41 pm
- Location: Herrliberg, Switzerland
Return to Calibration
Who is online
Users browsing this forum: No registered users and 31 guests