How to disable gimbal stablization

AutoQuad AV/AP settings, gimbal & servo choices

How to disable gimbal stablization

Postby auhouhz » Sat Jun 29, 2013 11:14 am

Hi, I have a small FPV camera with tilt servo that I've connected to the port 10 of AQ and control it using the AUX 3 (Ch8) knob on my DX8

Radio & Control, Control setup, Gimbal Tilt = Channel 8.
Mixing & Output, Gimbal ports, Roll off, Pitch = 10.

As I am using it for flying FPV, I do not need the stabilization function. I only need to control the tilt for take off and landing. I cannot find any option to turn off the stabilization. Please help.

Thank you.
auhouhz
 
Posts: 9
Joined: Sun Apr 21, 2013 12:15 pm

Re: How to disable gimbal stablization

Postby joebar.rc » Sat Jun 29, 2013 11:16 am

There is not an option for that, but you could try it with the roll and pitch scaler in the gimbal section setting it close to 0 or even 0.
joebar.rc
 
Posts: 1084
Joined: Fri Jun 22, 2012 8:59 am
Location: The netherlands

Re: How to disable gimbal stablization

Postby auhouhz » Sat Jun 29, 2013 12:39 pm

In that case, how can I wire my servo so I can use one channel and port for a simple pwm output? Without assigning it to a gimbal function.
auhouhz
 
Posts: 9
Joined: Sun Apr 21, 2013 12:15 pm

Re: How to disable gimbal stablization

Postby joebar.rc » Sat Jun 29, 2013 6:55 pm

You can't, we've made a gimbal pass though code some while ago but I don't know if it in the development trunk yet. But as said, only for the gimbal.
Also a servo trigger is coded, but simply assign a port to pass though any channel we didn't make.
joebar.rc
 
Posts: 1084
Joined: Fri Jun 22, 2012 8:59 am
Location: The netherlands

Re: How to disable gimbal stablization

Postby auhouhz » Sun Jun 30, 2013 1:41 pm

Thanks for the explaination, may I know how can I use the trigger port? Wiring and setting. Thank you.
auhouhz
 
Posts: 9
Joined: Sun Apr 21, 2013 12:15 pm


Return to Camera & Gimbal support

Who is online

Users browsing this forum: No registered users and 1 guest

cron