by Mullet » Sun Sep 27, 2015 10:05 pm
brat002 - I think you have to set HOTT to 0 in the telemetry section of QGC. I believe I had this when I was setting up my Micro Minim OSD.
Joerg - so it looks like since I have a DX7s I can only use AUX2 as an analog pot, thus only changing AM1 or AM2, not both at the same time. Otherwise, is there another way to set this up? Does the M4 give a beeper indication (if one is attached) when changing values? One of the nice things about CleanFlight and a Naze32 board is that it will do this when doing in-flight programming.