Hi, all.
This is my first time to use Quatos.
I had some problems:
1.Based on AQ wiki, for Quatos Thrust curve measurement, "Note down these numbers and copy them into the RPM and thrust culumns of this spreadsheet."
I can arm and start motors; but, what command to down these numbers?
2.When I armed my motors with Quatos FW and ESC32, from the mid-throttle to the max-throttle, the speeds of motors were same. If I used non-Quatos FW, the speeds of motors changed depending on the value of throttle.
What is the problem?
Thanks for help.
Jet