I still haven't done this yet. I decided to go with the Naze32 for my Raven 234. I figured since the frame is an acro frame I might as well go in that direction. Suffice to say, I'm going to commit and build a 180mm class FPV and I think AQ would be a good choice for this.
I'm going to go with the Turnigy thrust stand. I couldn't locate the Krick one. I did find a few others besides the Turnigy one...
http://www.infinity-hobby.com/main/prod ... s_id=10375http://www.mcssl.com/store/7af87a7dbaa0 ... rbg7U.dpufI'm going to go with 12A KISS ESC for this build. So I'd need to get a hold of Menno's firmware.
I think this will work for a setup... Thrust Stand, Turnigy 7-in-1 multimeter (Don't need this to do Thrust curve measurement, but it's helpful), 12A ESC (might or might not use KISS for test), Turnigy Tachometer, Transmitter (DX7s), Lemon 8ch DSM receiver, DYS 1306 3100kV motors.
I figure I'll use the tachometer to know what RPM I'm at and just apply throttle till I get to 300, 600, etc. RPMs.