Yep, that was a typo... I meant 1.6.2. Thanks for pointing it out!
-Max
Error in PID QGC
17 posts
• Page 2 of 2 • 1, 2
Re: Error in PID QGC
by Max » Thu Mar 05, 2015 12:44 pm
- Max
- Posts: 2814
- Joined: Mon Aug 13, 2012 9:45 pm
- Location: Near Ithaca, NY, USA
Re: Error in PID QGC
by plexus » Thu Mar 05, 2015 6:21 pm
Hi Max,
Thanks for your job Max . I will test very soon because I am building an X8 at that time to replace my Hexa.
Alain
Thanks for your job Max . I will test very soon because I am building an X8 at that time to replace my Hexa.
Alain
- plexus
- Posts: 534
- Joined: Tue Jul 03, 2012 3:30 pm
- Location: South of France
Re: Error in PID QGC
by plexus » Mon Mar 09, 2015 7:34 pm
Hi ,
No change, not possible to do an offset Y. An error is occured in the QGC 1.6.3
i am surprise to be the only one to get that problem.
Alain
No change, not possible to do an offset Y. An error is occured in the QGC 1.6.3
i am surprise to be the only one to get that problem.
Alain
- plexus
- Posts: 534
- Joined: Tue Jul 03, 2012 3:30 pm
- Location: South of France
Re: Error in PID QGC
by plexus » Tue Mar 10, 2015 11:32 am
in the xml file with an offsetY=0.08 I get that error .
Without offset Y no problem. See attached file:
Without offset Y no problem. See attached file:
test.xml- (1.56 KiB) Downloaded 768 times
- plexus
- Posts: 534
- Joined: Tue Jul 03, 2012 3:30 pm
- Location: South of France
Re: Error in PID QGC
by Max » Tue Mar 10, 2015 6:38 pm
That's no error, just a warning about the mix balance since your CoG is off.
-Max
-Max
- Max
- Posts: 2814
- Joined: Mon Aug 13, 2012 9:45 pm
- Location: Near Ithaca, NY, USA
17 posts
• Page 2 of 2 • 1, 2
Return to Quatos Adaptive Control
Who is online
Users browsing this forum: No registered users and 5 guests