I have measured ma Air Fram geometry and entered it into the quatos tool for calculation of the parameters.
The resulting values were imported into QGC and transmitted to my nanoHexa, but this is resulting in strange motor mix values, the sum of all values for toll are not equal to 0 and a warning is displayed.
How can this happen?
Attached my XML file
- M4_NanoHexa.xml
- (1.74 KiB) Downloaded 804 times
- M4-NanoHexa-Parameters.txt
- (5.47 KiB) Downloaded 752 times
Any help would be appreciated. Currently I am a little bit reluctant doing the maiden with these parameters.