Page 1 of 1

CAN wiring question

PostPosted: Sat Oct 04, 2014 11:01 am
by stefannn
Hello,

I have a question regarding the correct wiring of the CAN bus.

Do the wires need to go directly from the ESC-1 L and H pads to the ESC-2 L and H pads like shown below?

can_20141004b.jpg
can_20141004b.jpg (163.62 KiB) Viewed 3446 times


Or is it OK to go line by line from the PCB like in the second picture below?

can_20141004a.jpg
can_20141004a.jpg (146.38 KiB) Viewed 3446 times


Thank you for your comments and
cheers,

Stefan

Re: CAN wiring question

PostPosted: Sat Oct 04, 2014 12:15 pm
by joebar.rc
2nd pic, it is a bus where you 'plug in' every can -l can-h in parallel

Menno

Re: CAN wiring question

PostPosted: Sat Oct 04, 2014 12:33 pm
by stefannn
joebar.rc wrote:2nd pic, it is a bus where you 'plug in' every can -l can-h in parallel

Menno


Hello Menno,

great, Thank you. I thought so.

Cheers,

Stefan