CAN wiring question

Info & Discussions about good ole AQ6, taken to the next level.

CAN wiring question

Postby stefannn » Sat Oct 04, 2014 11:01 am

Hello,

I have a question regarding the correct wiring of the CAN bus.

Do the wires need to go directly from the ESC-1 L and H pads to the ESC-2 L and H pads like shown below?

can_20141004b.jpg
can_20141004b.jpg (163.62 KiB) Viewed 1643 times


Or is it OK to go line by line from the PCB like in the second picture below?

can_20141004a.jpg
can_20141004a.jpg (146.38 KiB) Viewed 1643 times


Thank you for your comments and
cheers,

Stefan
stefannn
 
Posts: 22
Joined: Sat Aug 30, 2014 1:32 pm

Re: CAN wiring question

Postby joebar.rc » Sat Oct 04, 2014 12:15 pm

2nd pic, it is a bus where you 'plug in' every can -l can-h in parallel

Menno
joebar.rc
 
Posts: 1084
Joined: Fri Jun 22, 2012 8:59 am
Location: The netherlands

Re: CAN wiring question

Postby stefannn » Sat Oct 04, 2014 12:33 pm

joebar.rc wrote:2nd pic, it is a bus where you 'plug in' every can -l can-h in parallel

Menno


Hello Menno,

great, Thank you. I thought so.

Cheers,

Stefan
stefannn
 
Posts: 22
Joined: Sat Aug 30, 2014 1:32 pm


Return to AQ6 +DIMU +CAN

Who is online

Users browsing this forum: No registered users and 4 guests

cron