CAN wiring question
Posted: Sat Oct 04, 2014 11:01 amHello,
I have a question regarding the correct wiring of the CAN bus.
Do the wires need to go directly from the ESC-1 L and H pads to the ESC-2 L and H pads like shown below?
Or is it OK to go line by line from the PCB like in the second picture below?
Thank you for your comments and
cheers,
Stefan
I have a question regarding the correct wiring of the CAN bus.
Do the wires need to go directly from the ESC-1 L and H pads to the ESC-2 L and H pads like shown below?
- can_20141004b.jpg (163.62 KiB) Viewed 11731 times
Or is it OK to go line by line from the PCB like in the second picture below?
- can_20141004a.jpg (146.38 KiB) Viewed 11731 times
Thank you for your comments and
cheers,
Stefan