Page 2 of 2

Re: AQGC and Calibration with DIMU very hard !!!

PostPosted: Mon Apr 28, 2014 9:58 pm
by Max
I'm afraid I have to defer the calibration question to others who may have a clue.. :) Except to ask, did you check the DIMU checkbox in the calib GUI? And to say, you may need to post your log(s) somewhere for others to test out (zip 'em so they're smaller). I do know that in the past, the quality of the dynamic data could definitely affect the calculations (but you probably knew that already).

-Max

Re: AQGC and Calibration with DIMU very hard !!!

PostPosted: Mon Apr 28, 2014 10:00 pm
by plexus
I will see that to morrow . have a nice night.
Alain

File added , see up.

Re: AQGC and Calibration with DIMU very hard !!!

PostPosted: Tue Apr 29, 2014 11:34 am
by sandmen
Is the 003derniere-AQL.LOG, your dynamic log?
Please upload also your parameter file, you have created on the first step's.

What I can see, the dynamic log, is not too long :-)

What do you mean with " On step 2 and 3 the loop abort, on step 4 some ´NAŃ´????"
with loop aborted?


I did only a short check with your dynamic, if you switch on the DIMU check box, it should be fine.
But the dynamic dance is really short!

Re: AQGC and Calibration with DIMU very hard !!!

PostPosted: Tue Apr 29, 2014 8:27 pm
by plexus
Hi,
003derniere-AQ.log is my dynamic log
and the 3 static log. The number 3 (horizontal) is that used and giving bad results

https://www.dropbox.com/s/8srt5ta2jkozl ... 042014.zip

You said the log is short, may be I must do a new dance slowly.
Step 2and 3 abort after some loops and step 4 finish but no values printed ( "NAN").

The dimu box was sticked.I am using the qgc 1.4 B.

May be you will see something wrong .
Thanks.
Alain

Re: AQGC and Calibration with DIMU very hard !!!

PostPosted: Thu May 01, 2014 7:09 pm
by plexus
After a lot of time to dance, my own parameters now seems to be good. The calculation is done well and the flight was very good wtih an very strong wind.
I upload a video to show you.
alain