AQGC and Calibration with DIMU very hard !!!
Posted: Sun Apr 27, 2014 6:12 pm
First flight with dimu and param of Jussih (thanks to him) very very good.
AQGC 1.3,
Firm R380 or R372
Dimu 1.1
BUT I had had a lot of difficulties to do my parameters:
1)
Abort on sim3 I read to load sim.exe and cal.exe, ok done.
Write an command, OK done and done each time I launch QGC 1.3.0
But result 'NAN'
____Abort before the end of the loop
Sim 5 a lot of "abort"
and now I cannot load my params. params in the AQ6 crash of QGC !!!! I dont see why.
With an other file no problem.
2)
In QGC 1.3.0 I dont see anywhere to choice CAN or PWM in connection .
I can see the icon only when the qgc is not connected (see attached file), after connection they disappear. I dont know if I am in PWM or CAN.
Many thanks for the explanations.
Always happy with AQ !!!
AQGC 1.3,
Firm R380 or R372
Dimu 1.1
BUT I had had a lot of difficulties to do my parameters:
1)
Abort on sim3 I read to load sim.exe and cal.exe, ok done.
Write an command, OK done and done each time I launch QGC 1.3.0
But result 'NAN'
____Abort before the end of the loop
Sim 5 a lot of "abort"
and now I cannot load my params. params in the AQ6 crash of QGC !!!! I dont see why.
With an other file no problem.
2)
In QGC 1.3.0 I dont see anywhere to choice CAN or PWM in connection .
I can see the icon only when the qgc is not connected (see attached file), after connection they disappear. I dont know if I am in PWM or CAN.
Many thanks for the explanations.
Always happy with AQ !!!