AutoQuad Forum

I'm stuck with just a red light when flashing a firmware for the DIMU. I can only get the board to work if i flash a AIMU Firmware.
for example i can't load those
ftp://ftp.autoquad.org/3/334693_22529/a ... -dimu-1.1/
but with those
ftp://ftp.autoquad.org/3/334693_22529/a ... -6.1-aimu/
it works fine

Edit:
ok i got it now;-)
Seems like my usb cable was broken and only randomly worked and didnt work.

good to hear, enjoy new DIMU

I'm stuck with the red light and don't know what to do!

I installed the DIMU but cannot get past the red light with DIMU firmware: aqv7.0.r422.b1800-hwv6.1-dimu1.1

With non-DIMU it works just fine: aqv6.7.r224.b1400-rev1

This is all very new to me, so I really need help, and I need it all dummed down

Check again your solder job and dimu connectors. Only red led indicates dimu is not initialised corectly

Cheeeeers, bluuuu, checking solders did the trick

It's ALIVE

Now all I have to do is put in my first ever quad build and get that to fly, piece of cake

I'm walking on uncharted territory, it might be a small step for man, but sure feels like a giant leap for me!

No that should be correct, those pins are meant to be connected as far as I know.

both pins are connected to gnd

both pins are connected to Vcc!