AutoQuad Forum

CONFIRMED! e372 DIMU stores the parameters (made a quick test with RADIO TYPE and MOTOR OUTPUT) in ROM.
I've not tested if TARE is working so far.

She's now out for a data with the freezer; will report back tomorrow and post the results (will only do one leveled run as Jussi suggested).

Joerg

Hi,

just checked TARE function on r372.
It's only working when:
THROTTLE = LOW (0)
YAW = LOWER LEFT CORNER (-692)
PITCH = HIGH (+711)
ROLL = UPPER LEFT CORNER (-684)

DEBUG LED will be solid red when stick in these positions; HUD stops spinning and is perfectly level and working.

With PITCH in LOW position position the RADIO VALUES box show me -692.

Any commends?
I'm using a Spektrum AR9020 with two sats attached; the SRXL bus goes to the AQ6 (via custom cable; power supply comes from a motor output since onboard 3.3V LDO is not sufficient for powering AR9020+2x SAT + TM1000).

AR9020 - SRXL-bus acting as 'diversity sat receiver'

Hi Joerg

I use the subtrims to set the Radio values to +-700 and 0-1400 respectively.
I cant remember if I have the pitch reversed.

Cheers
Christof

Using r381 and board 6.1 DIMU is not saving the values on the ROM. Whenever I power cycle the AQ, it comes back to default parameters from Jussi which I loaded using SD card few days back.

Thanks for help issue resolved