AutoQuad Forum

Actually, I have the CAN transceivers and caps, and was planning to offer kits, but didnt get around to adding it to the shop. I will add them tonight.

thanks Jussi and Norbert.
On my side I prefer to have a kit DIY with all components for the dimu board and esc32. I have the equipment to solder all components sms.
Alain

It's great to hear that! Can someone post a list of all benefits of using DIMU? I have read somewhere that by using DIMU the magnetometer will no longer be used to determine correct level during flight, is that true?

Jussi

I ordered two AQ boards with DIMUs today.

I like the way you have your web shop setup, very nice.

Larry

Thanks, Larry.

The interest has been a bit overwhelming but I am working flat out to get all the DIMU and Basecam orders out end of tomorrow.

The webpage is all Norberts handywork - I am totally useless at that kinda stuff, but the really made it shine and does a great job keeping it safe, updated, maintained and ranking good. I would recommend him to anyone...

DIMUs are also available at Flyduino now: http://flyduino.net/Multcopter-FC_1

Most of them went out thursday and yesterday. Yours is still here along with about 15 more orders that goes out monday - your order takes a little more preparation to solder and setup a complete board.

Interest was much higher than anticipated, so all units was sold out from here in 10 hours, and I had 100' s of parcels to pack and ship and still only 2 hands.

Thanks for all your efforts Jussi! Hope your hands are still working after all that stuffing, sticking and shipping!

David

+1

Alain