Page 1 of 1

DIMU with latest firmware

PostPosted: Thu Feb 27, 2014 9:55 am
by kinderkram
Thx to Jussi and Max I flashed the trunk head r355 successfully on my AQ6 with DIMU 1.01 8-)
Jussi didn't manage to compile r345 for some reason so I had r340 from him and r355 from Max to test.

One (reproducible) problem occurred when trying to flash both firmwares with my Delta8 PPM receiver attached.
I got an error that only went away after I unplugged the receiver. After successful flashing I could edit the values as usual, set the motor mix and radio and everything works like it should incl. the tare function.

This might be helpful to know for upcoming testers. So don't attach anything else than the serial when flashing the fw.
Dunno if this happens with Spektrum or other radios...


Re: DIMU with latest firmware

PostPosted: Mon Mar 31, 2014 10:42 pm
by chschmid
The DIMUS v1.1 are out now.
Is the board_dimu_v2.h the right .h file?
The version numbering is a bit confusing.

What cal.exe (W) version is the right one to use?

Thaks for confirmation and directions.


Re: DIMU with latest firmware

PostPosted: Tue Apr 01, 2014 7:29 pm
by aBUGSworstnightmare

added DIMU to my AQ6 today, flashed it (via QGC - FTDI connection) with firmware aqv7.0.r368.b1697-hwv6.0-dimu1.1.hex and got stuck!

I'm unable to store any config parameter (radio type, mixing, ..) to ROM!

Any advice what's going wrong?


Re: DIMU with latest firmware

PostPosted: Tue Apr 01, 2014 9:55 pm
by kinderkram
Moved that topic to the matching forum.