AutoQuad Forum

David,
Which cal & sim3 binary's did you use?
Did you select the DIMU checkbox in qgc?

As long as I know are bad cal numbers mostly the fault of a bad dance log.

bn999 – That's very generous of you, I have uploaded them here:

http://www.horizonimaging.co.uk/rcgroup ... /autoquad/

sandmen - I used the standard GCS (version 133.00) as the only alternative cal and sim3 files I found (in ) were .exe files and I'm using a Mac ... I did have the "Using DIMU" checkbox ticked though.

Many thanks for your help guys

David

David,

I had no problems calculating your calibration parameters. Your data was extremely clean.

Attached is the param file with command lines that were used to generate each step. Also attached are the OSX executables that I used.

params.txt

(8.22 KiB) Downloaded 660 times

ground_calib_OSX.zip

(76.68 KiB) Downloaded 656 times

I'm sure the problem is in the qgc, and using the wrong simu params.

Wow you gents are too kind Thanks so much for doing the number crunching for me!

I'm on holiday (in Berlin) at the moment, but I look forward to getting these calibration files onto my AQ and doing the maiden flight of my X8 when I get home!

Where you did you get these cal files from bn999? Joerg's zip file contained .exe files but yours seem different?

Many thanks again for your help, David

Hey guys,

I just downloaded the cal and sim3, but i get this error:

dyld: Library not loaded: /usr/local/lib/gcc/x86_64-apple-darwin13.0.0/4.7.3/libgomp.1.dylib
Referenced from: /Users/raymondastudillo/Downloads/ground_calib_OSX/sim3
Reason: image not found
Trace/BPT trap: 5

Does anyone know how to fix this?

did you change in cal_version.txt from version 1.0 to 2.0 and save?

Hi Teramax,

Yes i changed the version number in the txt file(inside the app). I also tried to run cal and sim3 outside of the QGC app. But with the same results.
I also installed Xcode command line tools, as google was pointing me in that direction. But no luck so far.