Page 1 of 1

M4 LadyBird going crazy

PostPosted: Mon Apr 18, 2016 2:36 pm
by FTPSMB
I am very new to quadcopters I hope someone can help:)
Problem:
https://dl.dropboxusercontent.com/u/104 ... 52.MOV.mov


Spec:
Autoquad M4 v2r1

Setup:
Autoquad M4 Ladybird

Parameter:
Autoquad M4 Ladybird
http://autoquad.org/wp-content/uploads/ ... ird_V2.txt

I just want to fly normal so hope someone know this problem

Re: M4 LadyBird going crazy

PostPosted: Mon Apr 18, 2016 3:26 pm
by Max
Looks like a prop spinning the wrong way, the IMU flip/rotate is wrong, or something similar. All very common (and easy to make) setup mistakes.

Please verify that the props are spinning in the correct directions by only giving enough throttle to start them moving (can't tell from the video). Then save your actual onboard parameters (using QGC) and post them here.

Did you load firmware after receiving your M4, and if so, exactly which version did you install?

-Max

Re: M4 LadyBird going crazy

PostPosted: Mon Apr 18, 2016 4:54 pm
by whizz101
I had this problem, check your motor ports and the orientation of the board. I got a RTF from viacopter and i needed to change them.

Re: M4 LadyBird going crazy

PostPosted: Tue Apr 19, 2016 10:00 am
by FTPSMB
Hey guys
Thank you very much it was the IMU flip i needed to change:)
Again thank you for fast reply