Cannot select voltage sensor
Posted:
Thu Dec 03, 2015 9:50 am
by DirkM
Hi,
on the M4 the voltage is floating and the reason should be that I cannot select the "voltage sensor" in the groundstation - see pictures. I have connected the battery voltage on the ADC. M4 is connected with N4.
Any ideas?
Dirk
Re: Cannot select voltage sensor
Posted:
Thu Dec 03, 2015 10:18 am
by Max
Dirk, do you see the parameter SPVR_VIN_SOURCE in the Onboard Parameters tree? If yes, you can change the value manually to 1 (one), transmit to AQ, Write Flash, then restart the M4. If no, try re-flashing the firmware.
-Max
Re: Cannot select voltage sensor
Posted:
Thu Dec 03, 2015 10:37 am
by DirkM
no, only this parameters are into the tree. Should I try to re-flashing or is it another value?
Dirk
Re: Cannot select voltage sensor
Posted:
Thu Dec 03, 2015 11:30 am
by Max
Hmm, where did you get this firmware? The rev number and the build number don't match. Should be r4
42 b1848.
http://autoquad.org/wiki/wiki/whats-new ... r-31,-2014At any rate, w/out that parameter there is no way to set the voltage source.
-Max
Re: Cannot select voltage sensor
Posted:
Thu Dec 03, 2015 3:41 pm
by DirkM
Hi Max,
was an actual (Dez 2015) board from viacopter. I flashed it with the actual firmware and everything is ok.
Thank you!
Dirk