I have Autoquad M4 without Extension Board. The Firmware is aqv7.1.1852-hwv8.6-quatos-ext_esc.bin.
After arming in manualy mode i have 975us PWM signal on ESC input. If i increase throttle the motors start correct
at 1075us. But it's impossiple to regulate the motors with throttle. The PWM-Signal remains at 1075us.
The number of revolutions remains the same. The ESC-Settings are as follows:
Arm PWM: 975us
Min. PWM: 1000us
Start PWM: 1075us
Max. PWM: 1950us
What is wrong?