AQ M4 with PWM

[aqv88888]

I have Autoquad M4 without Extension Board. The Firmware is aqv7.1.1852-hwv8.6-quatos-ext_esc.bin.

After arming in manualy mode i have 975us PWM signal on ESC input. If i increase throttle the motors start correct
at 1075us. But it's impossiple to regulate the motors with throttle. The PWM-Signal remains at 1075us.
The number of revolutions remains the same. The ESC-Settings are as follows:
Arm PWM: 975us
Min. PWM: 1000us
Start PWM: 1075us
Max. PWM: 1950us

What is wrong?

[aBUGSworstnightmare]

[aqv88888]

I have a 5 digit Quatos key. It is registered at
System MWV 136
>LIC
LIC_KEY1 XXXXX
LIC_KEY2 0
LIC_KEY2 0

XXXXX is my 5 digit key. It's correct.
Is it the correct position?

[kinderkram]

Yep, but wrong key maybe...
You can check your AQ serial number and retrieve your key here: http://www.drone-controls.com/index.cfm ... icense.htm

[aBUGSworstnightmare]

[aqv88888]

Hello

I have the license Checks.
The code is correct.

or goes the M4 only in connection with the expansion board?

Many thanks

[chschmid]

[LPR]

How are you connecting your ESC without an expansion board?

The Kisssys expansion boards are the easiest way to connect nonCAN ESC.

ESC32 V2 or ESC32 V3 with CAN is also a good way to have motors controlled.

[aBUGSworstnightmare]

[aqv88888]