ripped of receiver signal pad M4
Posted:
Fri Sep 04, 2015 5:40 pm
by Astudillo
Hey guy's,
I accidentally ripped of the external receiver signal pad of my M4. I couldn't find a trace to follow it, is there another point i could solder a wire on?
Thanks,
Ray
Re: ripped of receiver signal pad M4
Posted:
Sat Sep 05, 2015 3:14 am
by Kisssys
Nothing easy, the signal line of the external receiver goes to pin 17 of the processor.
- Capture.JPG (73.84 KiB) Viewed 9240 times
Re: ripped of receiver signal pad M4
Posted:
Sat Sep 05, 2015 8:20 am
by Astudillo
Thanks Steve! Ill give it a try!
Re: ripped of receiver signal pad M4
Posted:
Mon Sep 07, 2015 4:52 pm
by Astudillo
Well it aint pretty, but it works just fine!
Thanks again Steve for pointing out the RX pin!
Cheers,
Ray
Re: ripped of receiver signal pad M4
Posted:
Tue Oct 06, 2015 6:21 pm
by Mullet
DarrellRog -
I'd suggest asking your question on rcgroups.com. There are plenty of experts on Cleanflight and Baseflight over there. This forum is primarily focused on the AutoQuad platform.