ripped of receiver signal pad M4

Info and discussion about the autonomous Micro FC, suitable for nanos, micros and mini multirotors

ripped of receiver signal pad M4

Postby Astudillo » Fri Sep 04, 2015 5:40 pm

Hey guy's,

I accidentally ripped of the external receiver signal pad of my M4. I couldn't find a trace to follow it, is there another point i could solder a wire on?

Thanks,

Ray
Astudillo
 
Posts: 139
Joined: Thu Apr 25, 2013 8:23 am
Location: Amsterdam, The Netherlands

Re: ripped of receiver signal pad M4

Postby Kisssys » Sat Sep 05, 2015 3:14 am

Nothing easy, the signal line of the external receiver goes to pin 17 of the processor.
Capture.JPG
Capture.JPG (73.84 KiB) Viewed 2790 times
Steve
Kisssys
Kisssys
 
Posts: 1340
Joined: Sat Jun 23, 2012 9:23 pm

Re: ripped of receiver signal pad M4

Postby Astudillo » Sat Sep 05, 2015 8:20 am

Thanks Steve! Ill give it a try!
Astudillo
 
Posts: 139
Joined: Thu Apr 25, 2013 8:23 am
Location: Amsterdam, The Netherlands

Re: ripped of receiver signal pad M4

Postby Astudillo » Mon Sep 07, 2015 4:52 pm

Well it aint pretty, but it works just fine!
IMG_3186.JPG


Thanks again Steve for pointing out the RX pin!

Cheers,

Ray
Astudillo
 
Posts: 139
Joined: Thu Apr 25, 2013 8:23 am
Location: Amsterdam, The Netherlands

Re: ripped of receiver signal pad M4

Postby Mullet » Tue Oct 06, 2015 6:21 pm

DarrellRog -

I'd suggest asking your question on rcgroups.com. There are plenty of experts on Cleanflight and Baseflight over there. This forum is primarily focused on the AutoQuad platform.
Mullet
 
Posts: 181
Joined: Sun Dec 28, 2014 5:56 am
Location: Fairfield County Connecticut


Return to AutoQuad M4 Micro Controller

Who is online

Users browsing this forum: No registered users and 2 guests

cron