M4v2 Dammaged ADC solder port

[ravenhaven]

Accidently liffted the ADC square solder port. After cleaning the damaged pad area I managed to resolder to a very small amount of copper trace and the board seems to be OK but I dont want to fly in this condition.
I would like some help if any one can inform me if I can solder to another point other than to the damaged ADC port and make a more secure solder point for voltage monitoring.
Thanks for any help.
Wally

[Kisssys]

The ADC pad goes to the via shown and R24. Soldering to the right side of the resistor should be a better spot but you need to use magnification to insure you don't short out anything. You could check the resistance between where your now connected to that point to double check. The green line shows the internal trace.

Cheers
Steve

2015-07-27_6-25-12.jpg (127.19 KiB) Viewed 6166 times

[ravenhaven]

Thanks for the quick reply to my problem. I have an old board that I bricked some time ago and will have a trail go at soldering a wire to the right side of R24 resistor of the old board. Its fairly open in that area so should not be a problem.
Thanks again for your help Steve.
Wally