M4v2 radio bind problem

[monkey1]

M4v2 internal Receivers can bind with Spektrum DX8 transmitter?

I have selected CYRF(onboard M4v2+) in QGC RC1 and already solder the bridge. Yellow debug LED Keep flashing. Then I make my spektrum DX8 in binding mode, the yellow LED does not go solid, bind failed.

I had tried RC1 in spektrum 10bit and spektrum 11bit, and no success.

What's the problem? Am I missing something?

[kinderkram]

CYRF on RC1 is the correct setup.
You waited 20 seconds for the M4 to go into binding mode?
Try to move the radio further away when binding. There have been reports of failures when the transmitter and receiver are too near.

[monkey1]

Thanks for tips, will ttry and let u know.

Thank you

[aBUGSworstnightmare]

As long as there is only the Cypress RX (onboard RX) you can also choose it as RC2.

Onboard RX selected under RC2 - bound to a DX8 (sorry, not picture) - on a M4V2

[monkey1]

yes, i can bind it. Since, i didnt installed the antenna cable. Even the transmitter got very close, it cannot be bind. After installed the antenna cable, it bind in a second as dsmx. Thank you kinderkram.