M4 motor runs when powered on.

Info and discussion about the autonomous Micro FC, suitable for nanos, micros and mini multirotors

Re: M4 motor runs when powered on.

Postby Kisssys » Wed Apr 29, 2015 12:08 am

Glad you got it working, we'll make note of the Fet replacement. Sometimes hot air is hard to control and using something like Chip Quik is a little easier. You need to have solder wick to get the special alloy off the board afterwards also.

http://www.mouser.com/ProductDetail/Chip-Quik/SMD1/?qs=sGAEpiMZZMsQWb9Zho8SKi7auGvpHfA5
Steve
Kisssys
Kisssys
 
Posts: 1340
Joined: Sat Jun 23, 2012 9:23 pm

Re: M4 motor runs when powered on.

Postby Mullet » Tue Sep 08, 2015 5:44 am

So I'm back bringing this one from the dead. Had another FET blow or go leaky as they say. Luckily had a replacement FET. However, Mouser says they're obsolete now. This looks like a suitable replacement...

78-SQ2310ES-T1-GE3

It looks like it has enough drain current - 6A. It's an N-channel mosfet... check. Any reason not to use it as a replacement?
Mullet
 
Posts: 181
Joined: Sun Dec 28, 2014 5:56 am
Location: Fairfield County Connecticut

Re: M4 motor runs when powered on.

Postby Kisssys » Tue Sep 08, 2015 1:39 pm

Should work fine.
Steve
Kisssys
Kisssys
 
Posts: 1340
Joined: Sat Jun 23, 2012 9:23 pm

Previous

Return to AutoQuad M4 Micro Controller

Who is online

Users browsing this forum: No registered users and 3 guests

cron