After a hard bounce/crash that resulted in the M4 coming into contact with some damp grass I am only getting a solid red light on boot.I don't think any significant moisture got on the board but its remotely possible something got a wet. After the crash motor m1 would turn on full power immediately upon battery being plugged in. M1 was going to full power prior to the power button being pressed and prior to any leds being lit!
I made sure the board was dry with a hair dryer as a precaution.
I then unplugged M1 and have tried to boot several ways without success. The motor does not try to go full power now when the battery is connected so I guess thats a step in the right direction.
I have tried-
-several different lipos and booting into bootloader and normally
-booting both ways with micro usb and lipo and combinations
-since I could get into bootloader I reflashed the board
-just left the board plugged into a battery for 10 minutes trying to boot
I just get a solid red led and QGC will connect but no boot info displayed.
I also considered that the boot loader button was stuck but that doesnt seem to be the case as I can only flash firmware by holding it and power on (so both buttons seem to work as they should).
I looked at the board under magnification and can see no damage or loose connections...
Any ideas or ways to troubleshoot?
Luke