Page 1 of 1

Active GPS antenna with M4

PostPosted: Mon Apr 06, 2015 12:23 am
by axi
Hello,
I have read that M4 v2 comes with MAX-M8Q module. I was thinking of using this active antenna http://www.tallysman.com/TW4821.php wich requires 3v. But I have doubts if Q module supports active antenna feed.

From ublox webpage:

Product variants
- MAX-M8C u-blox M8 concurrent GNSS LCC module,
crystal, ROM
- MAX-M8Q u-blox M8 concurrent GNSS LCC module,
TCXO, ROM
- MAX-M8W u-blox M8 concurrent GNSS LCC module,
TCXO, active antenna supply, ROM


So it seems only MAX-M8W have active antenna supply.

Anyone can enlight me about this?

Thanks in advance,


Post edit:

Right now the multi constellation accuracy it's better than only GPS signal? are GLONASS, Beidou and Galileo supported on Autoquad firmware?

Re: Active GPS antenna with M4

PostPosted: Mon Apr 06, 2015 12:47 am
by bn999
Yes, the M4v2 will supply 3.3v to an active antenna. The AQ firmware will make use of all GNNS available.

I would not say that absolute accuracy increases while using multiple GNNS, but I have notices improved velocity estimates which for AQ is just as important as position accuracy. The biggest improvement actually comes from advancements in the UBlox M8 engine itself.

Re: Active GPS antenna with M4

PostPosted: Mon Apr 06, 2015 1:00 am
by axi
Thank you very much for the info!